Z-Wave signal repeater with temperature and humidity sensor

The Neo signal repeater extends the Z-Wave network signal to distances of up to 80-100 meters, increasing the network coverage and allowing the addition of more devices.
The network will reconfigure automatically, each device choosing the most efficient route to the controller.

Do you want to use that flood sensor in the basement, but the Z-Wave signal is too weak? Use the Neo signal repeater!

Warning! The repeater extends the signal for devices with the S0, S2_Unauthenticated and S2_Authenticated security classes, but not S2_Access! Smart Z-Wave locks configured in S2_Access mode (recommended) will not benefit from the repeater function. For the security of your smart home, install the hub near the lock.

Benefits:
- Extends the Z-Wave signal
- Reports temperature and humidity

Specifications:
- Power supply: 85 - 240V, 50/60 Hz AC;
- Protocol: Z-Wave Plus
- Operating temperature: 0℃ - 40℃
- Operating humidity: 20-85%, without condensation
- Detects temperatures between -20 and +80 ℃ (+/- 1 ℃);
- Detects humidity in a range of 0 - 100% relative humidity (+/- 1 percent);
- Range of action: maximum 100m outside, no obstacles; maximum 80m indoors (depending on wall thickness, construction materials, etc.)